The latest installation method for continuous hoist

Question

Accepted Answer

The continuous hoist is suitable for continuous conveying of powdery, granular and small block materials with large abrasiveness, such as grain, coal, cement, crushed ore, etc. The conveying height is up to 40M, with simple structure and stable operation. Pick-up type, mixed or gravity unloading, the rim adopts a combination sprocket for easy replacement, the sprocket rim has a long special service life, and the lower part adopts the gravity automatic tensioning device to maintain a constant tension. The following is the installation method of the continuous hoist:

1. The continuous hoist is divided into two types according to the shape of the hopper: the S method - with a deep garden bottom hopper; the Q method - with a shallow garden bottom hopper

2. The continuous hoist is divided into two types according to the upper section discharge port: X1 method - discharge port with inclined flange; X2 method - discharge port with horizontal flange

3. The form of the inlet section of the continuous hoist is divided into two types: J1 method - the slope of the inlet is 45 degrees from the horizontal plane; J2 method - the slope of the inlet is horizontal 60 degree angle

4. The continuous hoist is divided into four types according to the position of the side inspection door of the middle casing: K1 method--the lower side left inspection door on the side of the middle casing; K2 method--the lower side of the middle casing with the lower right view Door; K3 method - the upper side of the middle casing with the upper left inspection door; K4 method - the middle casing side with the upper right inspection door

5. The continuous hoist is divided into two types according to the position of the inspection door at the end of the middle casing: Z1 method--the end of the middle casing has the lower inspection door; Z2 system--the middle casing end with the upper inspection door

6. According to the transmission device, the relative position of the continuous hoist is divided into two types: left installation - transmission on the left side; right installation - transmission on the right side.